Sherline 1165 Sherline WW and 8 mm Collet Fixtures
The collet fixture was designed to be mounted either on the surface of the rotary table or on the mill table. A knurled ring allows WW collets to be tightened without the use of a drawbolt from the back. This is particularly useful for clockmakers for gearcutting on a gear blank that has a pinion shaft attached that can be held in a collet. A bushing is provided that fits into the center hole of the rotary table and helps locate the fixture on center. T-nuts and attaching screws are also provided for clamping the fixture in place in the rotary table or mill table T-slots. Use P/N 1164 with Sherline and similar WW collets which have a .312-.313 body diameter. Use P/N 1165 with other brand 8.0 mm collets measuring .314-.315 in body diameter. (The P/N 1165 fixture is identified by a groove cut around the body which is not present on the P/N 1164 holder.)
CA Prop 65 WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use dust mask or other safeguards for personal protection.
I can do all this through him who gives me strength. Philippians 4:13