Free UPS Ground Shipping in Continental US,
Powermatic 1791284 TS29 Shaper, 7.5HP 3PH 230/460V
The new TS29 Tilt/Slide Shaper is ready to tackle any job. A new fence design includes dual digital readouts, micrometer adjustments and independently adjustable fence halves for fast, accurate set-ups. The full guard includes two stock hold-downs and a see-through cover that flips up for quick tool changes. Dual dust collection ports, in the guard and under the table insure a clear work area and improved finish. An extra large quill assembly with a full seven inch stroke has three oversize bearings and the ability to tilt, adding versatility and insuring long, trouble-free performance. Powered by a big 7-1/2HP motor that drives the spindle forward and reverse with five speeds. The massive sliding table is fully supported by six tapered precision bearings through a full four-foot stroke. In addition, on board the table is a large miter head complete with stock hold-down clamp and a 56" miter fence with flip stop. The large table can easily accommodate a stock feeder for longer production runs
Features:
- Sliding table with 4-foot stroke works with miter head, hold-down and fence to accommodate everything from multiple end cuts to tenons
- Fully adjustable fence with dual digital readout for fast, accurate set-up and repeatability
- Large table with built-in slider with room for stock feeder
- 7" vertical spindle travel allows stacked tooling
- Spindle tilts negative 5° to positive 45° for increased versatility
- Large diameter multiple table inserts accommodate virtually any size cutter
- Five spindle speeds in forward and reverse with lighted indicator
Specifications:
- Style (Type)Shaper
- Spindle Speed (RPM)
3,000, 4,000, 6,000, 8,000, 10,000
- Maximum Spindle Diameter (In.)
1-1/4
- Spindles Included
3/4, 1, 1-1/4
- Spindle Size Under Nut (In.)
3/4 (3-1/2), 1 (6), 1-1/4 (6-1/2)
- Spindle Travel (In.)
7
- Spindle Tilt (Deg.)
45 Forward, 5 Back
- Reversible Yes
- Router Bit Collet Included
1/4, 1/2
- Maximum Diameter Cutter Above Table (In.)
12
- Maximum Diameter Cutter Below Table (In.)9
- Table Inserts (In.)
2-1/5, 5-1/2, Oval (Tilting)
- Table Size (In.)
51-1/2 x 33-1/2
- Table Travel (In.)
49-1/4
- Sliding Table Size (In.)
11-1/4 x 51-1/4
- Fence Size (L x H) (In.)
46 x 5
- Fence Travel (Major and Minor) (In.)
5-3/8, 3-5/8
- Dust Port Outside Diameter (In.)
5 (x2)
- Dust Collection Minimum CFM Required (CFM)
800
- Electrical Controls
24 volt
- Motor Power (HP)
7-1/2
- Motor Phase 3
- Motor Voltage (V.)
230/460
- Prewired Voltage (V.)
230
CA Prop 65 WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance know to the State of California to cause cancer. Avoid inhaling wood dust or use dust mask or other safeguards for personal protection